What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
09.06.2025 04:35

Here is a simplified AC power diagram.
It seems Mohan does not understand the difference between a comment and an Answer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Aussie firms Soul Patts and Brickworks' $9 billion merger sends their shares rocketing - CNBC
The other is “what does a “fuse” do?”
a photo is worth a thousand words.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
He then asserts :
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
what exactly is a ‘surge’ protector?
Ryan Blaney hits right notes in Nashville, lands first Cup Series win of season - NASCAR.com
An AC voltage/ current source, and an ac inductive load.
At least they know the answer if they wanted it.
but this device (an Inductor) … impedes the rapid changes in the current.
'Club World Ca$h Grab': Players don protest shirts at pregame - Sounder at Heart
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
[old diagram got deleted by accident]
He then describes Rainy Season and Lightning.
Has your wife made you a cuckold?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
In schematic diagrams this is the symbol for a fuse:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
but I think this circuit , shows a few more pieces.
Barnstars:
Edit 2024–10.
Mario Kart World Is Not An Open-World Game, Nintendo Says - GameSpot
First Sentence:
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Because the load is inductive, the current lags the voltage.(by a bit).
Youth overdoses from synthetic opioids are increasing. What parents should know - CNN
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is where this question deviates from being a 'generic' question, and becomes more specific.
It also is a device that limits the change in current flow.
Incredible auroras delight stargazers in New Zealand photo of the day for June 2, 2025 - Space
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
the problem then depends on "how fast does the fuse operate?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A fuse is a non-resetable over current circuit protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But… the neutral is now “floating” because of the 1 ohm resistance.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[image of Common-mode choke]
This is where the MOV conducts again, and dissipated the energy.
For this case there are devices called Metal oxide varistors (MOV).
These are simplified answers to the original question, and does not change anything I wrote above.
This one hit behind the barn.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This device then solves the entire problem.
2024–10–16 [ OO OLAOYE OYEBODE ]
(Dc diagram shown, AC is similar).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What does a fuse do?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
eight
The third is lightning and “how it gets conducted into a home.”
There are three different concepts here that are getting confused.
But it can get overloaded, and no longer works.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What is lightning?
One
So, the voltage could go up to 500 volts, and the fuse will not open up.
There are two important concepts here.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Upvotes:
He then describes the function of a fuse.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
The bolt then partially travels down the line to your home.
2024–10–14 [Omar Gharbi Omar Gharbi ]
At one ohm, the resistor has a maximum of 1 watt power.
so, what happens?
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–10[John johnson John Johnson ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
One is “what exactly is in a ‘surge protector’ ? ”
A circuit breaker is similar, but is resettable.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Now when you have a certain ac resistance, then a current flows in a loop.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
These devices are installed between the “hot” and “neutral” and protective ground.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
nine
I post the exact comment here.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is 'the assistant's answer'